R&S WinIQSIM2 Software Manual - Rohde & Schwarz

R&S ® WinIQSIM2
Graphical User Interface
Baseband Block
where n ranges from 0 to (Carrier Stop - Carrier Start).
Remote command:
​[:​SOURce]:​BB:​ARBitrary:​MCARrier:​EDIT:​CARRier:​POWer:​STEP​
on page 220
Phase Start
Sets the phase of the carrier marked by "Carrier Start".
Remote command:
​[:​SOURce]:​BB:​ARBitrary:​MCARrier:​EDIT:​CARRier:​PHASe[:​STARt]​
on page 220
Phase Step
Sets the step width that is used to increment the phase.
The resulting phase in the carrier table equals:
PhaseStart + n* PhaseStep
where n ranges from 0 to (Carrier Stop – Carrier Start)
Remote command:
​[:​SOURce]:​BB:​ARBitrary:​MCARrier:​EDIT:​CARRier:​POWer:​STEP​
on page 220
Delay Start
Sets the delay of the carrier marked by "Carrier Start".
Remote command:
​[:​SOURce]:​BB:​ARBitrary:​MCARrier:​EDIT:​CARRier:​DELay[:​STARt]​
on page 218
Delay Step
Sets the step width that is used to increment the delay
The resulting delay in the carrier table equals:
DelayStart + n* DelayStep
where n ranges from 0 to (Carrier Stop – Carrier Start).
Remote command:
​[:​SOURce]:​BB:​ARBitrary:​MCARrier:​EDIT:​CARRier:​DELay:​STEP​
on page 218
Input Waveform File
Calls the "File" menu for selecting the inputfile with the I/Q signal to be modulated onto
all carriers of the selected carrier range.
Remote command:
​[:​SOURce]:​BB:​ARBitrary:​MCARrier:​EDIT:​CARRier:​FILE​ on page 219
Software Manual 1008.0858.42 ─ 10
102