R&S WinIQSIM2 Software Manual - Rohde & Schwarz

R&S ® WinIQSIM2
Remote Control Commands
SOURce:BB:ARB:WSEG Subsystem
Example:
MMEM:CDIR 'D:/user/waveform'
sets the default directory to D:/use/waveform.
BB:ARB:WSEG:CONF:CAT?
reads out all the configuration files in the default directory.
Response: mulit1, multi2
the directory contains the configuration files multi1.inf_mswv
and multi2.inf_mswv.
Usage:
Query only
Manual operation: See "Load List" on page 111
[:SOURce]:BB:ARBitrary:WSEGment:CONFigure:CLOCk
This command defines the clock rate used for multi segment waveform output in case of
Clock Mode "User" (:BB:ARB:WSEG:CONF:CLOCk:MODE USER).
Parameters:
Example:
float
Increment: 1E-3
*RST: max SampleRate
BB:ARB:WSEG:CONF:CLOC:MODE USER
selects Clock Mode User.
BB:ARB:WSEG:CONF:CLOC 50MHz
defines a clock rate of 50 MHz.
Manual operation: See "User Clock Rate" on page 109
[:SOURce]:BB:ARBitrary:WSEGment:CONFigure:CLOCk:MODE
This command selects the clock rate mode for the multi segment waveform.
Parameters:
UNCHanged | HIGHest | USER
UNCHanged
The segments are output with the clock rate defined in the waveform
file. Extended Trigger Mode "Next Segment Seamless"
(:BB:ARB:TRIG:SMOD NSEam) can only be selected if all segments
have the same clock rate. Extended Trigger Mode "Next
Segment" (:BB:ARB:TRIG:SMOD NEXT) can only be selected if
trigger mode "Internal" is selected (:BB:ARB:TRIG:SOUR INT).
HIGHest
The segments are output at the highest available clock rate.
USER
The segments are output with the clock rate defined with command
:BB:ARB:WSEG:CONF:CLOC
*RST:
UNCHanged
Software Manual 1008.0858.42 ─ 10
226