R&S WinIQSIM2 Software Manual - Rohde & Schwarz

R&S ® WinIQSIM2
Remote Control Commands
SOURce:BB:DM Subsystem
Note: Sequence Length * Oversampling must not exceed the maximum number of samples
in the arbitrary waveform generator.
Parameters:
float
Range: 1.0 to max
*RST: 10000
Example: BB:DM:SLEN 500
sets the sequence length to 500 symbols.
Manual operation: See "Sequence Length - Digital Modulation" on page 65
[:SOURce]:BB:DM:WAVeform:CREate
This command creates a waveform using the current settings of the "Digital Modulation"
menu. The file name is entered with the command. The file is stored with the predefined
file extension *.wv. The file name and the directory it is stored in are user-definable.
Setting parameters:
Example:
Usage:
string
MMEM:CDIR 'd:/user/waveform'
sets the default directory to d:/user/waveform.
BB:DM:WAV:CRE 'dm_1
creates the waveform file dm_1.wv in the default directory.
Setting only
Manual operation: See "Generate Waveform File - Digital Modulation" on page 65
7.8.1.2 Marker Settings
[:​SOURce]:​BB:​DM:​TRIGger:​OUTPut:​MODE​......................................................237
[:​SOURce]:​BB:​DM:​TRIGger:​OUTPut:​OFFTime​..................................................238
[:​SOURce]:​BB:​DM:​TRIGger:​OUTPut:​ONTime​....................................................239
[:​SOURce]:​BB:​DM:​TRIGger:​OUTPut:​PATTern​...................................................239
[:​SOURce]:​BB:​DM:​TRIGger:​OUTPut:​PULSe:​DIVider​..........................................239
[:​SOURce]:​BB:​DM:​TRIGger:​OUTPut:​PULSe:​FREQuency?​.................................240
[:SOURce]:BB:DM:TRIGger:OUTPut:MODE
The command defines the signal for the selected marker output.
Software Manual 1008.0858.42 ─ 10
237