R&S WinIQSIM2 Software Manual - Rohde & Schwarz

R&S ® WinIQSIM2
Graphical User Interface
Baseband Block
5.10.2.2 Coding - Custom Digital Mod
Modulation symbols are coded directly before I and Q values or frequency shifts are
assigned. Coding is thus directly related to modulation methods, which is the reason why
codings are not freely combinable with modulation methods. The following table shows
which of the coding combinations are available and defines the modulation types for
which the various coding procedures can be used.
In the notation used below an denotes the n-th input symbol and bn denotes the correspondingly
coded output symbol. Individual bits in the symbols from the LSB (least significant
bit) to the MSB (most significant bit) are denoted by a0n, a1n and so on. The
same applies to the output symbols.
Table 5-5: Permissible coding combinations for modulation symbols and modulation type
OFF
Differential
Phase
Diff.
Diff.
+Gray
Gray GSM NADC,
PDC,
PHS,
TETRA,
APCO25
(PSK),
PWT
TFTS/
TETRA
INMARSAT,
ICO,
WCDMA,
cdma2000
VDL
APCO25
(FSK)
APCO25
(8PSK)
ASK X X X X
BPSK X X X X
pi/2 DBPSK X X
QPSK X X X X X
QPSK EDGE X
QPSK45° Offset
X X X X
Pi/4 QPSK X X X
Pi/4 DQPSK X X X X
8PSK X X X X X
AQPSK X X X X
OQPSK X X X X
8PSK_EDGE X
Pi/8 D8PSK X X X
MSK X X X X X
2FSK X X X X X
4FSK X X X X X
8FSK X X X X
16FSK X X X X
16QAM X X X X X
16QAM EDGE X
32QAM X X X X X
Software Manual 1008.0858.42 ─ 10
55