R&S WinIQSIM2 Software Manual - Rohde & Schwarz

R&S ® WinIQSIM2
Remote Control Commands
SOURce:BB:ARB:MCAR Subsystem
Parameters:
Example:
float
Range: 0 to 1
Increment: 1E-9
*RST: 0
Default unit: s
BB:ARB:MCAR:CARR15:DEL 5us
sets a start delay of 50 us for carrier 15.
Manual operation: See "Carrier Table" on page 103
[:SOURce]:BB:ARBitrary:MCARrier:CARRier:FILE
The command selects the file with I/Q data to be modulated onto the selected carrier.
Parameters:
Example:
BB:ARB:MCAR:CARR15:FILE 'D:/IQ_wcdma'
selects file IQ_wcdma. The data of the file is modulated onto carrier
15.
Manual operation: See "Carrier Table" on page 103
[:SOURce]:BB:ARBitrary:MCARrier:CARRier:FREQuency
Sets or indicates the carrier frequency, depending on the selected carrier frequency
mode.
The carrier frequnecy can be set in "Arbitrary Carrier frequency" mode. For "Equidistant
Carrier Spacing", the carrier spacing is determined automatically.
Parameters:
Example:
integer
The value range is determined by the max bandwidth of the
selected target instrument, ARB or Vector Signal Generator.
Increment: 1
*RST: 0
BB:ARB:MCAR:CARR:MODE ARB
activates ARB multi carrier mode.
BB:ARB:MCAR:CARR:FREQ 5.0
sets 5.0 MHz carrier frequency.
Manual operation: See "Carrier Table" on page 103
[:SOURce]:BB:ARBitrary:MCARrier:CARRier:PHASe
The command sets the start phase of the selected carrier.
The phase settings are only valid if optimization of the crest factor is disabled
(:SOURce:BB:ARB:MCARrier:CFACtor:MODE OFF).
Software Manual 1008.0858.42 ─ 10
213