R&S WinIQSIM2 Software Manual - Rohde & Schwarz

R&S ® WinIQSIM2
Remote Control Commands
R&S Signal Generator Waveform and List Format
Example:
Usage:
{COMMENT: File with data for 3GPP enhanced
channels}
BB:ARB:WAV:TAG? 'COMMENT'
queries the content of the COMMENT tag of the selected waveform
file.
Response: 'File with data for 3GPP enhanced
channels'
the comment on the waveform reads "File with data for 3GPP
enhanced channels".
Setting only
{COPYRIGHT: string}
The tag contains an ASCII string of arbitrary length. The string is not analyzed in the R&S
WinIQSIM2. It is used to store copyright information about the file content.
Example:
Usage:
{COPYRIGHT: Rohde&Schwarz}
BB:ARB:WAV:TAG? 'COPYRIGHT'
queries the content of the COPYRIGHT tag of the selected waveform
file.
Response: 'Rohde&Schwarz'
copyright resides with Rohde&Schwarz.
Setting only
{DATA BITLENGTH: BitLength}
(mandatory for data lists)
The tag contains the length of the data held in the DATA LIST tag in bits in ASCII format.
Example: {DATA BITLENGTH: 444}
BB:DM:DLIS:TAG? 'DATA BITLENGTH'
queries the content of the DATA BITLENGTH tag of the selected
data list file.
Response: '444'
the data list is 444 bits long.
Usage:
Setting only
{DATA LIST-Length: #d0d1...dx...dN-1…}
(mandatory for data lists)
The tag contains the actual bit sequence of the data list in binary format.
Setting parameters:
Length
Defines the number of bytes in the DATA LIST tag in ASCII Format
(for format see WAVEFORM length).
dx
Data bits in binary format (8-bit unsigned characters, MSB first).
Software Manual 1008.0858.42 ─ 10
171