R&S WinIQSIM2 Software Manual - Rohde & Schwarz

R&S ® WinIQSIM2
Graphical User Interface
Baseband Block
Clock Rate
Selects the clock rate of the blank segment.
Remote command:
​[:​SOURce]:​BB:​ARBitrary:​WSEGment:​CONFigure:​BLANk:​APPend​
on page 225
Samples
Selects the number of samples for the blank segment.
Remote command:
​[:​SOURce]:​BB:​ARBitrary:​WSEGment:​CONFigure:​BLANk:​APPend​
on page 225
Period
Displays the resulting period for the blank segment.
Remote command:
n.a.
Append Blank
Adds the blank segment to the multi segment file.
Remote command:
​[:​SOURce]:​BB:​ARBitrary:​WSEGment:​CONFigure:​BLANk:​APPend​
on page 225
5.10.5.3 Level / Clock /Marker
The Level/Marker/Clock section provides the parameters necessary to adjust the level,
marker and clock settings for the selected multi segment waveform file.
Level
Defines the level mode for the multi segment waveform.
"Unchanged"
"Equal RMS"
Conserning the level settings, the segments are output exactly as
defined in the files. The "Level" display applies only to the segment with
the highest rms value. In some circumstances the remaining segments
are output at a lower level than that displayed.
Segments are output so that all segments have the same rms value.
The "Level" display applies to all segments.
Remote command:
​[:​SOURce]:​BB:​ARBitrary:​WSEGment:​CONFigure:​LEVel[:​MODE]​
on page 227
Clock
Selects the clock rate mode for the multi segment waveform.
Software Manual 1008.0858.42 ─ 10
108