R&S WinIQSIM2 Software Manual - Rohde & Schwarz

R&S ® WinIQSIM2
Remote Control Commands
SOURce:BB:DM Subsystem
Parameters:
Example:
float
The range of values depends on the symbol rate that is set (see
data sheet) and the maximum deviation is 10 MHz.
Range: -40E6 to 40E6
Increment: 0.5
Default unit: Hz
BB:DM:FORM FSKV
selects Variable FSK modulation.
BB:DM:FSK:VAR:TYPE FSK16
selects 16FSK modulation.
BB:DM:FSK:VAR:SYMB0:DEV 135000
sets the frequency deviation of the least significant symbol to 135
kHz.
Manual operation: See "Deviation xxxx - Digital Modulation" on page 71
[:SOURce]:BB:DM:FSK:VARiable:TYPE
The command selects the modulation type for Variable FSK.
Parameters:
Example:
FSK4 | FSK8 | FSK16
*RST:
FSK4
BB:DM:FORM FSKV
selects Variable FSK modulation.
BB:DM:FSK:VAR:TYPE FSK16
selects 16FSK modulation.
Manual operation: See "FSK Type - Digital Modulation" on page 71
7.8.1.5 Power Ramp
[:​SOURce]:​BB:​DM:​PRAMp:​ATTenuation​..................................................................247
[:​SOURce]:​BB:​DM:​PRAMp:​FDELay​.........................................................................248
[:​SOURce]:​BB:​DM:​PRAMp:​RDELay​.........................................................................248
[:​SOURce]:​BB:​DM:​PRAMp:​SHAPe​..........................................................................248
[:​SOURce]:​BB:​DM:​PRAMp:​TIME​.............................................................................249
[:​SOURce]:​BB:​DM:​PRAMp[:​STATe]​.........................................................................249
[:SOURce]:BB:DM:PRAMp:ATTenuation
The command sets the level attenuation for signal ranges that are flagged with level
attribute attenuated by the LEV_ATT control signal.
Software Manual 1008.0858.42 ─ 10
247