R&S WinIQSIM2 Software Manual - Rohde & Schwarz

R&S ® WinIQSIM2
Remote Control Commands
SOURce:BB:ARB:WSEG Subsystem
Example:
BB:ARB:WSEG:CONF:CLOC:MODE UNCH
selects clock mode unchanged. The segments are output with the
clock rate defined in the waveform file.
Manual operation: See "Clock" on page 108
[:SOURce]:BB:ARBitrary:WSEGment:CONFigure:COMMent
This command enters a comment for the configuration file. The configuration file must be
specified with command :BB:ARB:WSEG:CONF:SEL.
Parameters:
Example:
string
BB:ARB:WSEG:CONF:COMM
enters comment "3gpp_up".
Manual operation: See "Comment" on page 110
[:SOURce]:BB:ARBitrary:WSEGment:CONFigure:DELete
This command deletes the configuration file. The configuration files are used to create
multi segment waveform files.
Setting parameters:
Example:
Usage:
string
MMEM:CDIR 'D:/user/waveform'
sets the default directory to D:/user/waveform.
BB:ARB:WSEG:CONF:DEL 'multi1'
deletes configuration file multi1.inf_mswv.
Setting only
Manual operation: See "Delete" on page 107
[:SOURce]:BB:ARBitrary:WSEGment:CONFigure:LEVel[:MODE]
This command selects the level mode for the multi segment waveform.
Parameters:
Example:
UNCHanged | ERMS
UNCHanged
The segments are output exactly as defined in the files.
ERMS
The segments are output so that all segments have the same rms
value.
*RST:
UNCHanged
BB:ARB:WSEG:CONF:LEV:MODE UNCH
selects level mode unchanged. The segments are output as
defined in the waveform file.
Software Manual 1008.0858.42 ─ 10
227