R&S WinIQSIM2 Software Manual - Rohde & Schwarz

R&S ® WinIQSIM2
Getting Started
Signal Configuration Examples
9. To display the baseband and AWGN signals, in the Main window, select "Graphics",
point to "Graphic 3", and click "Graphic 3 (Complete)".
The "Graphics" dialog opens.
10. Make the following entries:
●
●
"IQ Source" = Baseband+AWGN
"Mode" = FFT Magnitude
11. Close all graphics dialogs.
You can now see the graphical representation before summation with AWGN, with
AWGN only, and after the summation point (noise afflicted baseband signal).
4.3.6 Transmitting the Signal to the R&S AFQ
Before you can transmit the waveform to the R&S AFQ, you have to ensure that the
connection to the R&S AFQ is enabled. This is indicated by two thin lines leading from
the R&S WinIQSIM2 block to the "Arb Sig Gen" block.
Software Manual 1008.0858.42 ─ 10
23