R&S WinIQSIM2 Software Manual - Rohde & Schwarz

R&S ® WinIQSIM2
Remote Control Commands
MMEMory Subsystem
:MMEMory:CDIRectory
Changes the default directory for mass memory storage. The directory is used for all
subsequent MMEM commands if no path is specified with them. It is also possible to change
to a higher directory using two dots '..' .
Setting parameters:
Example: See ​"Working with Files and Directories" on page 190.
Usage:
Setting only
SCPI confirmed
:MMEMory:COPY [,]
Copies an existing file to a new file. Instead of just a file, this command can also be used
to copy a complete directory together with all its files.
It is also possible to specify the path using another parameter. The command is:
MMEMory:COPY
[,,
]
Setting parameters:
string
String parameter to specify the name of the file to be copied.
If is not specified, is copied to the
MMEM:MSIS drive and the MMEM:CDIR directory. Files which
already exist with the same name in the destination directory are
overwritten without an error message.
It is also possible to specify the path using another parameter. The
command is: MMEMory:COPY
[,,
]
file_destination
string
String parameter to specify the name of the new file. If no file destination
is specified, the source file is copied to the current directory,
queried with the MMEM:CDIR command. Files which already
exist with the same name in the destination directory are overwritten
without an error message.
Example: See ​"Working with Files and Directories" on page 190.
Usage:
Event
SCPI confirmed
Software Manual 1008.0858.42 ─ 10
192