R&S WinIQSIM2 Software Manual - Rohde & Schwarz

R&S ® WinIQSIM2
Remote Control Commands
SOURce:BB:ARB:WSEG Subsystem
Manual operation: See "Sequence Restart" on page 109
[:SOURce]:BB:ARBitrary:WSEGment:CONFigure:MARKer:MODE
Defines the way the marker information within the separate segments is processed.
Parameters:
Example:
IGNore | TAKE
IGNore
The marker information carried in the individual segment waveform
files is not considered.
TAKE
The output waveform file contains the marker information as configured
in the individual waveform files.
*RST:
TAKE
BB:ARB:WSEG:CONF:SEL 'ConfComm'
BB:ARB:WSEG:CONF:MARK:MODE TAKE
Manual operation: See "Segment Marker" on page 109
[:SOURce]:BB:ARBitrary:WSEGment:CONFigure:OFILe
This command defines the file name for the multi segment waveform. This file name is
stored in the configuration file and is used when a waveform is created (command
:BB:ARB:WSEG:CLOad or :BB:ARB:WSEG:CREate). The file extension is
*.wv.
Parameters:
Example:
string
MMEM:CDIR 'D:/user/waveform'
sets the default directory to D:/user/waveform.
BB:ARB:WSEG:CONF:SEL 'multi1'
creates the configuration file multi1.inf_mswv in default directory.
BB:ARB:WSEG:CONF:OFIL 'mseg1_2'
defines the file name mseg1_2.wv for the multi segment waveform
file created using configuration file multi1.inf_mswv.
Manual operation: See "Output file" on page 110
[:SOURce]:BB:ARBitrary:WSEGment:CONFigure:SEGMent:APPend
This command appends the specified waveform to the configuration file.
Setting parameters:
string
Software Manual 1008.0858.42 ─ 10
229