R&S WinIQSIM2 Software Manual - Rohde & Schwarz

R&S ® WinIQSIM2
Remote Control Commands
SOURce:BB:ARB:MCAR Subsystem
Usage:
Query only
Manual operation: See "Save/Recall Frame" on page 94
[:SOURce]:BB:ARBitrary:MCARrier:SETTing:LOAD
The command loads the settings file. If a settings file with the specified name does not
yet exist, it is created. The file extension may be omitted. Only files with the file extension
*.arb_multcarr will be loaded or created.
Setting parameters:
Example:
Usage:
string
BB:ARB:MCAR:SETT:LOAD 'D:/user/waveform/new'
creates settings file new.arb_multcarr.
Setting only
Manual operation: See "Save/Recall Frame" on page 94
[:SOURce]:BB:ARBitrary:MCARrier:SETTing:STORe
The command stores the current settings of submenu "Multi Carrier" in a file in the specified
directory. The file extension may be omitted, the files are stored with the file extension
*.arb_multcarr.
Setting parameters:
Example:
Usage:
string
BB:ARB:MCAR:SETT:STOR 'D:/user/waveform/mcarr2'
stores settings file mcarr2.arb_multcarr in the default directory.
Setting only
Manual operation: See "Save/Recall Frame" on page 94
[:SOURce]:BB:ARBitrary:MCARrier:SETTing:STORe:FAST
Determines whether the instrument performs an absolute or a differential storing of the
settings.
Enable this function to accelerate the saving process by saving only the settings with
values different to the default ones.
Note: This function is not affected by the "Preset" function.
Parameters:
0 | 1 | OFF | ON
*RST: 1
Manual operation: See "Fast Save" on page 65
Software Manual 1008.0858.42 ─ 10
223