Toshiba PROSEC T1-16S PLC User's Manual - CTi Automation

Basic ladder instructions (continued)
6F3B0253
7. Instructions
FUN
No.
Name Expression Function Steps Speed
(µs)
Page
− Counter C CNT Q Counts the number of cycles
E A B the count input (C) comes ON
while the enable input (E) is
ON, and turns ON output (Q)
when the count reaches to the
value specified by A. B is a
counter register.
2 22.6 132
− Master control set ⎥−−[ MCS ]−⎢ Turns OFF power rail between 1 3.75
− Master control reset ⎥−−[ MCR ]−⎢ MCS and MCR when MCS
input is OFF.
1
(in a
pair)
133
− Jump control set ⎥−−[ JCS ]−⎢ Jumps from JCS to JCR when 1 2.75
− Jump control reset ⎥−−[ JCR ]−⎢ JCS input is ON.
1
(in a
pair)
134
− End ⎥−−[ END ]−⎢ Indicates end of main program
or sub-program.
1 1.4 135
Data transfer instructions
FUN
No.
Name Expression Function Steps Speed
(µs)
Page
018 Data transfer −[ A MOV B ]− Transfers data of A to B. 3 4.2 136
019 Double-word
data transfer
−[ A+1⋅A DMOV B+1⋅B ]− Transfers double-word data
of A+1⋅A to B+1⋅B.
3 7.2 137
020 Invert transfer −[ A NOT B ]− Transfers bit-inverted data of
A to B.
3 4.6 138
022 Data exchange −[ A XCHG B ]− Exchanges data of A with B. 3 6.5 139
024 Table initialize −[ A TINZ (n) B ]− Transfers data of A to n
registers starting with B.
3 140
025 Table transfer −[ A TMOV (n) B ]− Transfers data of n registers
starting with A to n registers
starting with B.
3 141
026 Table invert −[ A TNOT (n) B ]− Transfers bit-inverted data of
transfer
n registers starting with A to
n registers starting with B.
3 142
090 Multiplexer −[ A MPX (n) B → C ]− Transfers data from the
register specified by B in the
table, size n starting with A,
to C.
5 70.6 176
091 Demultiplexer −[ A DPX (n) B → C ]− Transfers data from A to the
register specified by B in the
table, size n starting with C.
5 71.5 177
Basic Hardware and Function 107
CTi Automation - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.ctiautomation.net - Email: info@ctiautomation.net