LTV 1200 Operator's Manual - CareFusion Emergency Preparedness

Presets
Use the Presets section of the Extended Features menu to:
• Turn the Patient Query feature on or off
• Select the Patient Size so that the ventilator settings and Extended Features menu settings
are adjusted to accommodate the type of patient (infant, pediatric or adult)
Turning Patient Query on or off
1) After entering the Extended Features menu, turn the Set Value knob until PRESETS is
displayed and press the Select button.
2) Turn the Set Value knob until PTNT QUERY is displayed, press the Select button and either
QUERY ON or QUERY OFF is displayed.
3) Turn the Set Value knob until the desired setting is displayed and press the Select button.
If QUERY ON is selected, when the ventilator is next powered up and passes POST,
ventilation and alarm activation are suspended and the message SAME PATIENT is
displayed.
• To enable the suspended alarms and begin ventilation with the settings in use during
the last power cycle, press the Select button while SAME PATIENT is displayed
OR
• To enable the suspended alarms and begin ventilation with Presets values
appropriate for a new patient, turn the Set Value knob until NEW PATIENT is
displayed and press the Select button. Then turn the Set Value knob until the
desired patient type is displayed (INFANT, PEDIATRIC or ADULT) and press the
Select button
• Turning the Set Value knob until EXIT is displayed and pressing the Select
button returns the ventilator to the SAME PATIENT menu option/message
If no controls are activated for three (3) seconds while either the SAME PATIENT or NEW
PATIENT options are being displayed, an audible alert sounds. Activation of any control
resets the 3 second delay of the audible alert.
If QUERY OFF is selected, when the ventilator is powered up and passes POST, it will begin
ventilation (appropriate alarms enabled) using the settings in use during the last power cycle.
Selecting Patient Size
1) After entering the Extended Features menu, turn the Set Value knob until PRESETS is
displayed.
2) Press the Select button.
3) Turn the Set Value knob until PATIENT SIZE is displayed and press the Select button.
4) Turn the Set Value knob until the desired patient type is displayed (INFANT, PEDIATRIC or
ADULT) and press the Select button to set the Presets values appropriate for the patient
type selected.
Operator’s Manual LTV ® 1200 Ventilator Page 10-23
p/n 18247-001, Rev. G