LTV 1200 Operator's Manual - CareFusion Emergency Preparedness

Protective Boot Installation
Supplies/Tools Required:
• Item (1), Protective Boot, Upper (1) P/N 19033-001 (Purple)
• Item (2), Protective Boot, Lower (1) P/N 19032-001 (Purple)
• Replacement Screws Kit, P/N 11149
• Torque wrench (20 in-oz / 0.14 Nm to 60 in-oz / 0.42 Nm range)
• Phillips-head screwdriver
To Install the Upper Protective Boot 75 :
1) Carefully place and support the disconnected ventilator in an upright position on a clean, dry
surface.
2) Using a Phillips-head screwdriver, remove the two upper back panel pan-head and two side
panel flat-head mounting screws indicated in the illustration.
• Do not remove the mating finish washers.
3) Orient the upper protective boot (1) over the ventilator as shown in the illustration (next page).
Move the boot down into position on the top of the ventilator and align its four screw holes with
the corresponding holes in the ventilator back and side panels.
4) Insert and thread two #4-40 flat-head mounting screws with finish washers (6) through the screw
holes in the legs of the upper boot, as indicated in the illustration (next page).
75 Refer to page C-8 for information concerning the appropriate accessories mounting screws or accessories
replacement screws location, type and length to use when removing or exchanging external accessories on an
LTV ® ventilator.
Page C-6 LTV ® 1200 Ventilator Operator’s Manual
p/n 18247-001, Rev. G