LTV 1200 Operator's Manual - CareFusion Emergency Preparedness

Cleaning or replacing the Inlet Filter
To clean the Inlet Filter:
1) Remove the Inlet Filter by squeezing the foam filter gently with your fingers and pulling it out.
2) Gently bathe the filter in a solution of mild detergent and warm water.
3) Rinse thoroughly in warm water.
4) Examine the filter for excessive wear or damage. Discard and replace with a new filter if
necessary.
5) Allow the filter to thoroughly air dry before reinstallation.
6) Reinstall the filter.
CAUTION
Wet or Damp Filters - Do not install a wet or damp filter into the LTV ® 1200 ventilator. This could
damage the ventilator.
ATTENTION
Filtres mouillés ou humides - Ne pas installer des filtres mouillés ou humides dans les ventilateurs
de la 1200 LTV ® . Cela pourrait endommager le ventilateur.
Operator’s Manual LTV ® 1200 Ventilator Page 13-3
p/n 18247-001, Rev. G