LTV 1200 Operator's Manual - CareFusion Emergency Preparedness

Recommendations

Info

Ventilator Proper Operation Worksheet SERIAL NUMBER: ________________ CONDUCTED BY: _______________________ DATE: ________________ TEST DESCRIPTION PAGE / STEP Ventilator Checkout Tests (Chapter 11 -) MEAS. VALUE REQUIREMENT PASS / FAIL Alarm Test 11-3 Audible alarm must activate for minimum 2 sec’s. Confirming audible Chirp must activate after alarm is silenced Display Test 11-4 All displays must light except Vent Inop Control Test 11-6 Correct messages displayed in window Leak Test 11-8 “X.X PASS”, Record value displayed Vent Inop Alarm Test 11-10 Alarm sounded and Inop LED illuminated 15 sec’s. Confirming audible Chirp must activate after alarm is silenced Checking the Ventilator for Proper Operation (Appendix C - Installation and Checkout): Ventilator Settings: Settings: Mode: Volume, Assist/Ctrl Low Press O2: Off Breath Rate: 12 Tidal Volume: 500 Insp. Time: 1 sec O2%: 21 Sensitivity: 3 High Pressure Limit: 100 Low Pressure Alarm: 5 Low Min Vol: 1.0 PEEP: 0 C-18 2) A) Selected Monitors should read as follows: Exhaled Tidal Volume: 383 to 633 ml I:E Ratio : 1:3.8 to 1:4.2 Total Breath Rate: 12 bpm Total Minute Vol: 4.6 to 7.6 L No alarms Page C-20 LTV ® 1200 Ventilator Operator’s Manual p/n 18247-001, Rev. G
Procedure: Set the O2% control to 22% C-18 2) B) Reset O2% to 21 and clear the C-18 alarm. Set the Low Min. Vol. alarm to 10 L 2) C) Reset the Low Min. Vol. alarm to C-18 1.0 and clear the alarm. Set the Low Pressure alarm to 60. 2) D) Set the Low Pressure alarm to 5 C-18 and clear the alarm. Set the High Pres Limit to 10 cmH2O below the Peak Inspiratory Pressure. 2) E) Reset the High Pres. Limit alarm to C-18 100 and clear the alarm. 2) F) Disconnect the high pressure sense C-19 line from the ventilator 2) G) Reconnect the high pressure sense C-19 line and clear the alarm 2) H) Change control settings as follows: C-19 Mode: Pressure, Assist/Cntl Pressure Control: 20 PEEP: 20 2) I) Disconnect AC Adapter from Ventilator at pigtail cable connector. C-19 2) J) LOW O2 PRES alarm activates after a short pause LOW MIN VOL alarm activates LOW PRES alarm activates HIGH PRES alarm activates. DISC/SENSE alarm activates on the next breath Selected Monitors should read as follows: PIP: 36 to 44 cmH2O PEEP: 17 to 23 cmH2O No alarms activate POWER LOST alarm activates Battery Level LED illuminates showing the charge level. Ventilator continues to operate from the internal battery Operator’s Manual LTV ® 1200 Ventilator Page C-21 p/n 18247-001, Rev. G
Page 1:
LTV ® 1200 Ventilator / MR Conditi
Page 4 and 5:
Warranty Pulmonetic Systems warrant
Page 6 and 7:
Notice To Operators Unsafe Operatio
Page 8 and 9:
Chapter 6 - Controls...............
Page 10 and 11:
LPPS OFF...........................
Page 12 and 13:
Chapter 15 - Troubleshooting ......
Page 14 and 15:
Operator’s Safety Information All
Page 16 and 17:
WARNING Battery run time - When the
Page 18 and 19:
AVERTISSEMENT Personnel non qualifi
Page 20 and 21:
AVERTISSEMENT Concentration d’oxy
Page 22 and 23:
Cautions CAUTION Ventilator Sterili
Page 24 and 25:
CAUTION External Battery Pack - The
Page 26 and 27:
ATTENTION Nettoyage du panneau fron
Page 28 and 29:
Symbols Symbol Compliance 3 Title A
Page 30 and 31:
Indications for Use The LTV ® 1200
Page 32 and 33:
Information/Assistance For addition
Page 34 and 35:
Volume Control Breaths For Volume C
Page 36 and 37:
Pressure Control Breaths (cont) Pre
Page 38 and 39:
Spontaneous Breaths For Spontaneous
Page 40 and 41:
SIMV Mode SIMV mode is selected whe
Page 42 and 43:
NPPV Mode Non-invasive Positive Pre
Page 44 and 45:
Volume Pressure Ventilation The LTV
Page 46 and 47:
Setting a Control There are 5 kinds
Page 48 and 49:
Bright, Dim and Blank Control Displ
Page 50 and 51:
Control Locking The front panel con
Page 52 and 53:
Breath Rate Use the Breath Rate con
Page 54 and 55:
High Pressure Limit Use the High Pr
Page 56 and 57:
Inspiratory Hold An Inspiratory Hol
Page 58 and 59:
Expiratory Hold An Expiratory Hold
Page 60 and 61:
Inspiratory Time This control sets
Page 62 and 63:
Low Pressure The Low Pressure alarm
Page 64 and 65:
Low Pressure O 2 Source (cont.) NOT
Page 66 and 67:
Low Pressure O 2 Source (cont.) To
Page 68 and 69:
O 2 % (O 2 Flush) The O2% (O2 Flush
Page 70 and 71:
On/Standby This button switches the
Page 72 and 73:
Pressure Control This control estab
Page 74 and 75:
Select Use this button to change th
Page 76 and 77:
Set Value Knob Use the Set Value kn
Page 78 and 79:
Tidal Volume Use the Tidal Volume c
Page 80 and 81:
Page 6-30 LTV ® 1200 Ventilator Op
Page 82 and 83:
Battery Level The Battery Level ind
Page 84 and 85:
Charge Status The Charge Status ind
Page 86 and 87:
NPPV The NPPV 30 indicator LED is l
Page 88 and 89:
Automatic or Manual Data Display Sc
Page 90 and 91:
I:Ecalc xx:xx The Calculated I:E ra
Page 92 and 93:
Alarms APNEA, APNEA xx bpm When the
Page 94 and 95:
BAT EMPTY (cont.) NOTE When the bat
Page 96 and 97:
BAT LOW (cont) NOTE Internal Batter
Page 98 and 99:
DEFAULTS (cont.) The factory-set de
Page 100 and 101:
DISC/SENSE When the ventilator dete
Page 102 and 103:
HIGH O 2 PRES When the average oxyg
Page 104 and 105:
HIGH PRES When the pressure in the
Page 106 and 107:
HW FAULT When the ventilator detect
Page 108 and 109:
LOW MIN VOL When the exhaled minute
Page 110 and 111:
LOW PEEP When the patient circuit p
Page 112 and 113:
NO CAL DATA, NO CAL Monitor Display
Page 114 and 115:
POWER LOW When the ventilator is op
Page 116 and 117:
RESET / RESET 1 A RESET or a RESET
Page 118 and 119:
SBT > f When the Spontaneous Breath
Page 120 and 121:
SBT > f/Vt When the Spontaneous Bre
Page 122 and 123:
XDCR FAULT When a transducer autoze
Page 124 and 125:
H&L PEEP OFF The H&L PEEP OFF messa
Page 126 and 127:
LO f/Vt OFF The LO f/Vt OFF message
Page 128 and 129:
SBT TIME The SBT TIME message is di
Page 130 and 131:
Navigating the Extended Features Me
Page 132 and 133:
Apnea Interval Use this menu item t
Page 134 and 135:
Patient Assist Use the PNT ASSIST m
Page 136 and 137:
Variable Rise Time Use the Variable
Page 138 and 139:
Variable Time Termination Use the V
Page 140 and 141:
Leak Compensation Use the Leak Comp
Page 142 and 143:
O 2 Flush Use the O2 Flush option t
Page 144 and 145:
Software Version Use the Software V
Page 146 and 147:
Set Time Use the Set Time option to
Page 148 and 149:
Valve Home Position Use the Valve H
Page 150 and 151:
O 2 Cylinder Duration (cont.) 4) Tu
Page 152 and 153:
LTV ® 1200 Presets Table Feature/F
Page 154 and 155:
SBT Operations (cont.) When the Spo
Page 156 and 157:
Transducer Autozero Use the Transdu
Page 158 and 159:
Exhalation Flow Transducer Differen
Page 160 and 161:
Real Time Transducers Use the Real
Page 162 and 163:
Page 10-34 LTV ® 1200 Ventilator O
Page 164 and 165:
To enable the Ventilator Checkout m
Page 166 and 167:
Display Test Use the Display Test t
Page 168 and 169:
Control Test Use the Control Test t
Page 170 and 171:
Leak Test Use the Leak Test to test
Page 172 and 173:
Vent Inop Alarm Test Use the Vent I
Page 174 and 175:
Exit To exit the vent check mode an
Page 176 and 177:
To Turn the Ventilator On (cont.) I
Page 178 and 179:
Procedure for Control Mode Set Up S
Page 180 and 181:
Procedure for SIMV Mode Set Up Set
Page 182 and 183:
Procedure for NPPV Mode Set Up Set
Page 184 and 185:
LTV ® Ventilator Settings Checklis
Page 186 and 187:
Cleaning or replacing the Fan Filte
Page 188 and 189:
Cleaning or Replacing the O 2 Inlet
Page 190 and 191:
Cleaning the Exhalation Valve and R
Page 192 and 193:
ATTENTION Nettoyage du piège à ea
Page 194 and 195:
To clean the exhalation valve, sens
Page 196 and 197:
Page 13-12 LTV ® 1200 Ventilator O
Page 198 and 199:
Using the AC Adapter To run the ven
Page 200 and 201:
2) Connect the power connector on t
Page 202 and 203:
Using the Automobile Cigarette Ligh
Page 204 and 205:
CAUTION Release Button - To avoid d
Page 206 and 207:
Replacing the Automobile Adapter Fu
Page 208 and 209:
Caring for the Internal Battery The
Page 210 and 211:
Displays and Buttons Some of the sy
Page 212 and 213:
Symptoms Possible Causes What to Do
Page 214 and 215:
Ventilator Performance Symptoms Pos
Page 216 and 217:
Page 218 and 219:
Page 220 and 221: Symptoms Possible Causes What to Do
Page 224 and 225: Problem Possible Causes What To Do
Page 226 and 227: Alarm Name Displayed Alarm Priority
Page 236 and 237: MR Conditional System - Conditions
Page 238 and 239: WARNING • Put the MR Conditional
Page 240 and 241: Control Range Tolerance PIP LED Dis
Page 242 and 243: Fixed Alarms Control Range Toleranc
Page 244 and 245: Displays Packaging Display Range To
Page 246 and 247: Power Feature Range Tolerance / Ind
Page 248 and 249: Page A-10 LTV ® 1200 Ventilator Op
Page 250 and 251: Service Assistance For assistance i
Page 252 and 253: Protective Boots Rubberized protect
Page 254 and 255: • Item (1), Protective Boot, Uppe
Page 256 and 257: Protective Boot Installation Suppli
Page 258 and 259: To Install the Lower Protective Boo
Page 260 and 261: Patient Breathing Circuit - Connect
Page 262 and 263: Oxygen Lines - Connection Instructi
Page 264 and 265: Patient Assist Call System - Connec
Page 266 and 267: Using the Remote Alarm Cable Use th
Page 268 and 269: Checking the Ventilator for Proper
Page 272 and 273: Page C-22 LTV ® 1200 Ventilator Op
Page 274 and 275: Ventilation flow enters the Flow Va
Page 276 and 277: 5) Push the Select button. • xx:e
Page 278 and 279: Code Event Name Event Associated Al
Page 280 and 281: Event Codes by Event Name Event Nam
Page 282 and 283: Event Name Code Event Associated Al
Page 284 and 285: TERM DEFINITION Control mode A vent
Page 286 and 287: TERM DEFINITION PIP Peak Inspirator
Page 288 and 289: Page F-6 LTV ® 1200 Ventilator Ope
Page 290 and 291: Button Controls · 5-3 C Calculated
Page 292 and 293: Mean Airway Pressure · 8-2, 8-3 Mi
Page 294: X XDCR FAULT · 9-32, 15-21 XDCR ZE
show all

LTV 1200 Operator's Manual - CareFusion Emergency Preparedness

Create successful ePaper yourself

Delete template?

Save as template?