LTV 1200 Operator's Manual - CareFusion Emergency Preparedness

Procedure:
Set the O2% control to 22% C-18
2) B)
Reset O2% to 21 and clear the C-18
alarm. Set the Low Min. Vol. alarm
to 10 L
2) C)
Reset the Low Min. Vol. alarm to C-18
1.0 and clear the alarm.
Set the Low Pressure alarm to 60.
2) D)
Set the Low Pressure alarm to 5 C-18
and clear the alarm.
Set the High Pres Limit to 10
cmH2O below the Peak Inspiratory
Pressure.
2) E)
Reset the High Pres. Limit alarm to C-18
100 and clear the alarm.
2) F)
Disconnect the high pressure sense C-19
line from the ventilator
2) G)
Reconnect the high pressure sense C-19
line and clear the alarm
2) H)
Change control settings as follows: C-19
Mode: Pressure, Assist/Cntl
Pressure Control: 20
PEEP: 20
2) I)
Disconnect AC Adapter from
Ventilator at pigtail cable connector.
C-19
2) J)
LOW O2 PRES alarm activates after a short
pause
LOW MIN VOL alarm activates
LOW PRES alarm activates
HIGH PRES alarm activates.
DISC/SENSE alarm activates on the next
breath
Selected Monitors should read as follows:
PIP: 36 to 44 cmH2O
PEEP: 17 to 23 cmH2O
No alarms activate
POWER LOST alarm activates
Battery Level LED illuminates showing the
charge level.
Ventilator continues to operate from the
internal battery
Operator’s Manual LTV ® 1200 Ventilator Page C-21
p/n 18247-001, Rev. G