Contents - Volkspage

11.6 Bodywork and fittings
13.1 Removing the locking knob 13.2 Slide the inner handle surround
to the rear to remove it
13.3a Removing the exterior mirror
control knob. . .
13.3b . . . and boot 13.4a Prise out the trim cover. . . 13.4b . . . unscrew the mounting
screws. . .
13.4c . . . and release the door pull
from the trim
13.5a Prise off the cover . . . 13.5b . . . remove the screw. . .
Removal
1 If required, unscrew and remove the locking
knob from the top of the inner trim panel (see
illustration). This is not essential as the trim
panel is slotted to allow it to be removed with
the knob in position.
2 Remove the inner handle surround by
sliding it to the rear (see illustration).
3 Remove the exterior mirror control knob
and boot from the top of the door pull (see
illustrations).
4 Prise the trim cover from the door pull,
remove the cross-head screws, then move
the rear of the door pull outwards. Note the
location lug (see illustrations).
13.5c . . . and withdraw the window
regulator handle from the splines
5 Note the position of the window regulator
handle with the window shut then prise off the
cover, remove the cross-head screw and
withdraw the handle (see illustrations).
6 Where applicable, remove the self-tapping
screws and withdraw the storage compart-
13.7 Cross-head screw securing the inner
trim panel to the door
ment panel. This is not required on all models.
7 Prise out the stoppers and remove the
cross-head screws from the trim panel (see
illustration).
8 Using a wide blade screwdriver carefully
prise the trim panel clips from the door inner