Contents - Volkspage
Contents - Volkspage
Contents - Volkspage
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Jacking and vehicle support REF.5<br />
The jack supplied with the vehicle tool kit To raise the front of the vehicle, position the To raise the rear of the vehicle, position the<br />
should only be used for changing the jack with an interposed block of wood jack with an interposed block of wood<br />
roadwheels - see “Wheel changing” at the underneath. Do not jack the vehicle under the underneath. Do not attempt to raise the<br />
front of this book. When carrying out any sill, sump, or any of the steering or vehicle with the jack positioned underneath<br />
other kind of work, raise the vehicle using a suspension components. With the vehicle<br />
the floor pan or axle. With the vehicle raised,<br />
hydraulic (or “trolley”) jack, and always raised, an axle stand should be positioned<br />
an axle stand should be positioned beneath<br />
supplement the jack with axle stands beneath the vehicle jack location point on the<br />
the vehicle jacking location point on the sill.<br />
positioned under the vehicle jacking points. sill. Position a block of wood with a groove cut<br />
When using a hydraulic jack or axle stands, in it on the jack head to prevent the vehicle<br />
Position a grooved block of wood on the jack<br />
always position the jack head or axle stand weight resting on the sill edge; align the sill as described in the previous paragraph.<br />
head under one of the relevant jacking points, edge with the groove in the wood so that the Never work under, around, or near a raised<br />
indicated by indentations at the lower edges vehicle weight is spread evenly over the vehicle, unless it is adequately supported on<br />
of the bodywork (see illustrations). surface of the block stands.<br />
Workshop hoist/trolley jacking point for the front of the vehicle<br />
Workshop hoist/trolley jacking point for the rear of the vehicle<br />
Radio/cassette unit anti-theft system - precaution<br />
The radio/cassette unit may be equipped security code has been entered. Therefore, if To enter the security code, follow the<br />
with a built-in security code, to deter thieves. you do not know the correct security code for instructions in the radio/cassette handbook.<br />
If the power source to the unit is cut, the antithe<br />
radio/cassette unit do not disconnect<br />
If an incorrect code is entered, the unit will<br />
theft system will activate. Even if the power<br />
become locked, and cannot be operated.<br />
source is immediately reconnected, the radio/ either of the battery terminals, or remove the If this happens, or if the security code is lost<br />
cassette unit will not function until the correct radio/cassette unit from the vehicle. or forgotten, seek the advice of your dealer.