C•CURE 800/8000 Software Configuration Guide - Tyco Security ...

Configuring a DoorTo Choose Door Monitors and Relays1. From the Configure Door dialog box, double-click in the Door switchmonitor field to open the Input Selection Browser. Select the input that isbeing used for this door’s Door switch monitor.2. Double-click in the Door latch relay field to open the Output SelectionBrowser. Select the output that is being used for this door’s Door latchrelay.3. If the Door has an Alternate shunt relay, double-click in the Alternateshunt relay field to open the Output Selection Browser. Select the outputthat is being used for this door’s Alternate shunt relay.4. If the Door has a Shunt expiration relay, double-click in the Shuntexpiration relay field to open the Output Selection Browser. Select theoutput that is being used for this door’s Shunt expiration relay.5. Click OK to save the Door settings, or continue configuring the Dooroptions by performing the steps in “Configuring Door Timers” onpage 5-6.Configuring Door TimersPerform the following steps to configure the door timers for a DoorTo Configure Door Timers1. From the Configure Door dialog box, in the Delay relock field, type thenumber of seconds to delay door relock after the door is opened (after arequest to exit, for example).2. In the Shunt time field, type the number of seconds that the door canremain open before a door held open alert is generated.3. In the Unlock time field, type the number of seconds the Door remainsunlocked after a valid card swipe, RTE activation, or momentary unlock.4. In the Alternate shunt time field, type the number of hours, minutes, andseconds the Door can remain open before a door held open alert isgenerated after a valid card swipe by a cardholder with the AlternateShunt flag set in their personnel record (This value is used only if it is setto a greater time than the Shunt time value).5–6 C•CURE 800/8000 Software Configuration Guide