C•CURE 800/8000 Software Configuration Guide - Tyco Security ...

Configuring Areas7. Repeat Steps 1 through 6 to create a second Area called AreaB.NOTETo assign antipassback, area lockout, occupancy restrictions, and escortedaccess to an area, two areas must be configured so that an exit area can beassigned.8. From the Area Selection browser, select Area1 and click Edit.9. Click the Access In tab and select a reader that you would like to use asthe inbound reader in this area, and click Add.10. The Select an exit area for this reader dialog box appears. Select AreaBfrom the drop-down box. (If you now click on the Access out tab you willsee the other reader assigned to this panel and the appropriate area isselected as your outbound reader and area.)11. Click OK in the Area Configuration dialog box to close the dialog.12. Select AreaB from the Area Selection browser and click Edit. TheConfigure Area dialog box appears.13. Click the Access in tab, and note that the second reader is alreadyconfigured as the Entrance reader for the area. When you click the AccessOut tab, note that the first reader is already configured as the Exit Reader,exiting to AreaA.The result of this example is two Areas with a single Door between them, withReader1 providing both entry to AreaA and exit to AreaB, while Reader2provides entry to AreaB and exit from to AreaA.Now that the Areas are configured, the next step would be to add settings forPassback, Area Lockout, Occupancy, Supervision, and Events, as needed.Configuring Area LockoutThe Area Lockout feature allows you to configure an area to lock out specifiedpersonnel or personnel groups from the area for a specified period of time.The areas configured can be single area, or area groups and the timer startswhen the personnel enters or exits the Lockout area.2–16 C•CURE 800/8000 Software Configuration Guide