C•CURE 800/8000 Software Configuration Guide - Tyco Security ...

Configuring Intrusion Zone InputsAs soon as the configuration is downloaded to the iSTAR, the change is ineffect and the protection input is active and monitoring the area withinthe intrusion zone.• When the intrusion zone is disarmed and no controlled or protectioninputs are active in the zone, the LCD reader (if configured to display“status”) cycles between “Ready to Arm” and “Present Card.”If the protection input becomes active, the reader LCD cycles between“Not Ready to Arm,” “Present Card,” and the first 16 characters of thename of the protection input. The active input is logged in the journaland displays on the Monitoring station, if the operator’s account wasconfigured to display the activity. If an Event was configured toactivate when the protection input becomes active, it also activates.• When the intrusion zone is armed and no other controlled or protectioninputs are active in the zone, the LCD reader display cycles between“Area Armed” and “Present Card.”If the protection input becomes active, the intrusion zone is violated,the LCD reader and the Monitoring station display the input activestatus, and a violation message, with named input, is logged in thejournal.• Example: arming/force arming an intrusion zone with an activeprotection input.• Arming an intrusion zone by normal means when a protection input isactive will result in a failure, with an entry in the activity log and nochange in status on the Monitoring station.• Force arming the intrusion zone with the active protection input willsuccessfully arm the intrusion zone.Because protection inputs are always armed, to permanently overridedefective hardware associated with a protection input, the input must bedeconfigured from the Admin Station.C•CURE 800/8000 Software Configuration Guide 12–23