C•CURE 800/8000 Software Configuration Guide - Tyco Security ...

Guard Tour Overview• Include Error checking that can cancel the tour if an error occurs. Errorsinclude expired card, tours stops out of sequence, and tour stops reachedtoo early.A guard must have a Personnel record in C•CURE 800/8000, and must beconfigured with the Can Perform Guard Tour Access Control option selected.See “Configuring Guard Tour Permission for Personnel” on page 9-12 forinstructions for configuring this setting. See the C•CURE 800/8000 PersonnelConfiguration Guide for more information about this setting.Guard Tour ActivationGuard Tours can be activated in either of two ways:• At the Monitoring Station by clicking Start Tour in the Configured GuardTours dialog box.• At the first stop on the guard tour if the check-in device is a readerconfigured as a tour initiating reader — configured in the ConfiguredTour Stops dialog box.Guard tours can be in one of the following states:• Offline• Online Inactive — no guard has been assigned to walk this tour.• Online Active In progress — a guard has been assigned to the tour and iscurrently walking it.• Online Active Suspended — a guard has been assigned to the tour and iscurrently walking it, but the tour has been temporarily suspended by anaction at the Monitoring Station client.NOTEThe same guard cannot be assigned to more than one active guard tour.Tour Stop Considerations• A tour stop can be configured to use either a card reader or an input as themonitoring device for the stop.• The same reader or input can be used to monitor multiple tour stops in asingle tour.C•CURE 800/8000 Software Configuration Guide 9–3