C•CURE 800/8000 Software Configuration Guide - Tyco Security ...

Keypad Command Configuration OverviewKeypad Command Configuration OverviewTable 13-1 on page 13-6 shows the dialog boxes and activities that createkeypad commands.Table 13-1: Creating Keypad CommandsTaskC•CURE 800/8000Dialog BoxConfiguration NotesAdditionalInformation1. Define thecommand formatOptions>SystemVariables>Keypad (tab)Defines the number of keypadcharacters in the command field(required).See “KeypadCommand Format”on page 13-8Defines the number of keypadcharacters in the prompt 1 andprompt 2 fields (optional).Important: You must restart C•CURE800/8000 after you define commandformat.2. Configure anddownload thekeypad eventConfigure>Event>Edit/New>EventsCreates and downloads the eventthat is activated by the keypadcommand.See “CreatingEvents” onpage 7-183. Configure thereaderHardware>Controller>Edit/New> Main Ext/1stACM Ext/2nd ACMExt>Reader>KeypadReader>KeypadConfigurationAllows one or more readers to acceptkeypad commands.See “ConfiguringReaders and ReaderMessages” onpage 13-144. Configure thekeypadcommandConfigure>KeypadCommand>Edit/New>ConfigureKeypad CommandCreates a keypad command andassociates it with:• The event it activates• The numerical sequence to thatexecute the keypad command.See “ConfiguringKeypad Commands”on page 13-125. Configure readerpromptsHardware>RM LCDMessages>New/Edit>Group 4 (Tab)Configures the reader to displayinformational prompts that helppersonnel to remember commands.Required only for commands that usePrompt 1 and Prompt 2.See “ConfiguringReaders and ReaderMessages” onpage 13-1413–6 C•CURE 800/8000 Software Configuration Guide