C•CURE 800/8000 Software Configuration Guide - Tyco Security ...

Protection Inputswhen the input is active or not active as part of the normal input configurationscreens. You may configure any or all of the protection inputs to activate thesame event.NOTEThe Monitoring Station will indicate the status of inputs configured for theIntrusion Zone but will not indicate which are controlled inputs andwhich are protection inputs. You may indicate this by choosingappropriate input names when configuring the inputs.Figure 12-3 on page 12-25 shows the location of the protection input menuselection.Figure 12-3: Protection Input selectionNOTEIf you configure the Protection Input column, you will not be allowed toconfigure the Entrance Delay Trigger or Entrance Delay Shunt options.C•CURE 800/8000 Software Configuration Guide 12–25