C•CURE 800/8000 Software Configuration Guide - Tyco Security ...

Configuring a Door7. Similarly, you can double-click in the Activation of this input determinesoutbound movement field to specify an input that is used to indicateoutbound movement (the input is triggered after the reader is activated),and set the activation time for the input in the Must activate within field.8. If you have identified an inbound asset reader or outbound asset reader,you can set Asset Linking Options for this Door.• If you want Asset Linking disabled, select Asset access linkingdisabled.• If you want to link asset movement to access control so that acardholder presenting a valid card while carrying a asset isautomatically granted access, select Link during passage.• If you want to link asset movement to access control so that acardholder presenting a valid card while carrying a asset is grantedaccess only after the access and authorization to move the asset are bothvalidated, select Validate links before opening.9. If you have enabled Asset Linking, you need to select how asset and cardaccess is evaluated.• If the physical layout of the entry door cannot guarantee which thesystem will detect first — cardholders’ access card or the asset(s) theyare carrying, select Link assets before and after card.• If the physical layout of the entry door guarantees that the asset(s) acardholder is carrying will be detected by the system before thepersons’s access card, select Link assets only before card.• If the physical layout of the entry door guarantees that a cardholder’saccess card will be detected by the system before the asset(s) that thecardholder is carrying, select Link assets only after card.10. Select Readers Are Continuously Active if you want readers to read andprocess cards even when the doors associated with them are momentarilyunlocked and/or open because of an operator or access request.11. Click OK to save the Door settings, or continue configuring the Dooroptions by performing the steps in “Setting Access Events” on page 5-9.5–8 C•CURE 800/8000 Software Configuration Guide