C•CURE 800/8000 Software Configuration Guide - Tyco Security ...

Configuring Nodes3. Enter a name for the node. This is the name that appears in the NodeSelection browser.4. In the Computer Name box, enter the name of your computer. The name(case sensitive) must be the same as it is set in the system Control Panel,Network Settings. To check the name, click the Control Panel icon,Network Settings, Identification tab.5. In the Available Permissions listbox, select the following permissionsyou want to assign to this node and click Add.Table 15-1: Available PermissionsPermissionsActivity PrintingAdministrationBadgingCertificateApprovalImagingMonitoringDescriptionLets users at this node use the real-time Activity Printer. When youselect this permission, the Configure activity printer for this nodebutton is enabled.Lets users at this node use the Administration application.Let users at this node take pictures, print and preview badges, takesignatures, edit badge layouts, and encode magnetic data and insert1D bar codes onto badges.This privilege allows a node to issue certificate approval forencryption. Only one node throughout the entire C•CURE 800/8000system can have Certificate Approval permission. If another nodealready has this permission, an error message is displayed and thepermission is not be added to the node. For more information aboutencryption, see the C•CURE 800/8000 Hardware ConfigurationGuide.Lets users at this node take capture images.Lets users at this node use the Monitoring Station.6. If you selected the Activity Printing permission, click the Configureactivity printer for this node button to configure the printer. The ActivityPrinter Configuration dialog box opens. See “Configuring the Real-timeActivity Printer” on page 15-6 and Figure 15-3 on page 15-7 for moreinformation.7. Click OK when finished to save the node permissions.15–4 C•CURE 800/8000 Software Configuration Guide