C•CURE 800/8000 Software Configuration Guide - Tyco Security ...

Configuring a DoorSetting Access EventsYou can specify the Access Events that are activated when a conditionsassociated with this Door occur. See Chapter 7, “Events” for more informationon defining the events that can be linked to the Door.To Set Access Events1. From the Configure Door dialog box, click the Access Events button. TheDoor Access Events dialog box appears.2. For each of the state changes that can happen at this door, if you want tolink an event to this condition, double-click in the field to open an EventSelection browser, and choose the event you want to link to thiscondition.3. Click OK to save the Door settings, or continue configuring the Dooroptions by performing the steps in “Setting Access Events” on page 5-9.Setting Asset EventsYou can specify the Asset Events that are activated when a conditionsassociated with this Door occur. See Chapter 7, “Events” for more informationon defining the events that can be linked to the Door.To Set Asset Events1. From the Configure Door dialog box, click the Asset Events button. TheDoor Asset Events dialog box appears.2. For each of the state changes that can happen at this door, if you want tolink an event to this condition, double-click in the field to open an EventSelection browser, and choose the event you want to link to thiscondition.3. Click OK to save the Door settings, or continue configuring the Dooroptions by performing the steps in “Setting Access Events” on page 5-9.C•CURE 800/8000 Software Configuration Guide 5–9