C•CURE 800/8000 Software Configuration Guide - Tyco Security ...

Configuring Intrusion Zones with AntipassbackDoor Behavior for IN and OUT doorsYou control how the door strike behaves and the Door State Monitor (DSM) isinterpreted with the IN and OUT selection. The truth table (see Table 12-11 onpage 12-32) shows all of the meaningful situations that you will encounter.NOTEWhen the door strike is active on a door with a DSM, you must open andclose the door for actions to take effect.Table 12-11: In and Out Door BehaviorDoorType Reader IZ State ActionActiveDSMDSMRequiredNotesIn Inbound Armed Disarm Yes Yes Armed zone is approached from the outsideand disarmed with card control. Disarmoccurs when door opens. Zone does notdisarm until door opens.In Inbound Not Armed Arm No No Zone is armed by card control from a readeroutside the zone. Arming does not activatethe strike.To distinguish from normal access, you mustpress CMD/ENT or present the card with anactive input to arm the zone.In Outbound Not Armed Arm Yes Yes Zone is armed from an inside reader. Doorstrike is activated to allow exit, and exit delayshould be configured. Zone does not arm untildoor opens and closes.In Outbound Armed Disarm No No Zone is disarmed from an inside reader. Yougain access through the door with anentrance delay, enter and disarm the zone.Motion sensor inputs covering entrance areamust be shunted to allow for disarm. Doorstrike does not activate because personnelare already inside the zone.Out Outbound Armed Disarm Yes Yes Armed zone is approached from the outsideand disarmed with card control. Disarmoccurs when door opens. Zone does notdisarm until door opens.12–32 C•CURE 800/8000 Software Configuration Guide