C•CURE 800/8000 Software Configuration Guide - Tyco Security ...

Two Phase AcknowledgementTo Enable Two Phase Acknowledgement1. Open Diag System by choosing Start>All Programs>C•CURE SystemDiagnostics>Diag System.2. Select Driver as the Section and TwoPhaseEventAck as the Entry.3. Set the Entry Value to 1 in the Settings in CCURE.INI box.4. Select MonitoringStation as the Section and NewEventScreen as theEntry.5. Set the Entry Value to 1 in the Settings in CCURE.INI box.6. Choose Personnel>Monitoring Privilege and click Edit for theMonitoring System Privilege that you want enabled for Two PhaseAcknowledgement.7. Under Options, clear the check box for Disable Two Phase Event ScreenControl.8. Optionally, click Two Phase Event Screen Control to open theMonitoring Station Event Screen Layout for Privilege dialog box if youwant to modify the appearance of the Acknowledge and Pending Clearpanes.For more information on using the Diag System, see Appendix A in theC•CURE 800/8000 Installation Guide.Event Sorting on Dual Split ScreenThe Dual Split Screen allows sorting by Date/Time and By Priority.To Sort By Date/Time1. Select Options>Sort Events By Date/Time from the drop-down menu.Events appear on the Dual Split Screen according to the date and timeoccurred.2. Within a set of events with the same date/time, the column sort order isdetermined by an entry in the CCURE.INI. Ascending order is the defaultcolumn sort. This means that within a set of events with the same date/time, the event with the oldest priority appears first.7–30 C•CURE 800/8000 Software Configuration Guide