C•CURE 800/8000 Software Configuration Guide - Tyco Security ...

Configuring a Door6. You can set timers for the inputs you have chosen by typing a time in thetimer field for your input. For example, if you have added a Bond sensorto the Selected Inputs for the door, you can set the timer for the input bytyping a time (in 1/10 seconds into the Bond sensor change time field.7. You can select Delay relock while door open after valid access if youwant to delay relocking of the door until it closes when a valid accessoccurs.8. You can select Shunt door for full shunt time if you want the door to stayunlock for the full shunt time, regardless of whether the door is open orclosed.9. Click OK to accept your changes and return to the Configure Door dialogbox.Configuring Double SwipeThe Double Swipe button on the Configure Door dialog box allows you toconfigure a door to enable its reader to interpret a double card swipe as ameans to toggle the door’s lock state for an indefinite amount of time. Performthe steps in the following section to configure the door for Double Swipe.NOTEThis feature is not supported by apC controllers.NOTEiSTAR firmware version 4.3 is required for this feature. This firmware isinstalled with the v9.3 application.NOTEThe Double Swipe feature should not be used with any other antipassback,escort, or intrusion zone functionality on the same door.It is helpful to configure the following objects in advance because you willneed to select from these objects to configure double swipe.a. The Event that occurs when a double swipe locks or unlocks a specificdoor.When a Lock Event becomes active, it deactivates the Unlock Event.Similarly, an activated Unlock Event deactivates a Lock Event.C•CURE 800/8000 Software Configuration Guide 5–11