C•CURE 800/8000 Software Configuration Guide - Tyco Security ...

Some Scenarios for Configuring E-mail and Pages2. Enter the name of the Comm port configured in Step 1 in the Port used fordirect connect paging service field on the Paging tab of the SystemVariables dialog box.3. Configure a carrier on the Carrier dialog box as follows:•In the Identification box, enter the name of the carrier and an optionaldescription, and select the Online check box to put the carrier online.•On the General tab in the Connection Type box, click Direct.•On the Options tab in the Connection Type box, enter the same baudrate as specified in Step 1 (9600 for Motorola People Finder LT) in theBaud Rate field. Also enter the maximum number of characterssupported be the local paging terminal (200 for Motorola People FinderLT) in the Maximum Characters field.4. Configure a paging recipient on the Recipient dialog box as follows:•In the Identification box, enter the person’s name and optionaldescription, and select the Online check box to put the recipient online.•In the Paging box, select the Enable check box, enter the PIN of theperson’s pager in the Page Pin field, and enter the name of the carrieryou configured in Step 3.5. Configure a page message about the antipassback violation on the PageMessage dialog box as follows:•In the Identification box, enter a message name and optionaldescription and select the Online check box to put the message online.•In the Recipient box, enter the name of the recipient you configured inStep 4.•In the Message Contents box, select at least one of the check boxes,such as Send date.6. Configure an event to send a page message, using the message youconfigured in Step 5.7. Configure an area to activate an event in the Entrance Event and/or ExitEvent fields when an antipassback violation occurs, using the event youconfigured in Step 6.When an antipassback violation occurs for the area, C•CURE 800/8000activates the event and the e-mail message is sent.16–20 C•CURE 800/8000 Software Configuration Guide