C•CURE 800/8000 Software Configuration Guide - Tyco Security ...

Configuring AreasConfiguring Events for Areas1. Select Configure>Area from the C•CURE 800/8000 Administrationapplication menu. The Area Selection Browser opens.2. Select the Area you wish to edit and click Edit. The Configure Areadialog box opens.3. Click the Events tab. For each of the access control situations listed, youcan specify an Event to activate when that situation occurs.Example:If you have configured antipassback provisions, you can set an Event toactivate on passback violation during entry.To assign an Event, double-click in the field and select an Event from theEvent Selection browser that appears. For more information on thesefields, see Area Events.4. Click OK when you have completed configuring Events for this Area.5. You can now continue by configuring occupancy settings for the Area.See “Configuring Occupancy Settings for Areas” on page 2-9 forinstructions.Configuring Occupancy Settings for AreasFrom the Configure Area Occupancy tab, you can optionally set occupancylimits for each Area, and use these limits either to restrict access, or to justcount the number of people in the Area and trigger an Event. You can alsolimit access to Personnel groups, and count access by Personnel Groupmembers.Maximum OccupancyMaximum Occupancy specifies the maximum number of personnel orpersonnel from a group, who can access an area at a time. If at any time, thenumber of personnel in an area exceeds the maximum number defined, allfurther access is denied unless personnel leave the area. You can alsoconfigure an event to trigger when an area reaches its maximum occupancy.You can also configure maximum occupancy to count the number ofpersonnel entering and leaving an area without restricting access.C•CURE 800/8000 Software Configuration Guide 2–9