C•CURE 800/8000 Software Configuration Guide - Tyco Security ...

Configuring Incident Groups for TrackingNOTETo ensure that all monitored activities and activity messages tagged withthe Incident ID are sent to both the Monitoring Station and the Journal, theSend state changes of this event to monitoring station and Send statechanges of this event to journal check boxes on the Event dialog box andthe Send state changes to monitoring station and Send state changes tojournal check boxes on the Input dialog box must be selected.The unique Incident ID is reused within an Incident Group until both thefollowing parameters are met:• All events inside of the group are fully acknowledged and cleared• All monitored activities of inputs change from an active state to aninactive state.When the driver is restarted, a new Incident ID is issued to an Incident Group.Example:• Incident Group A contains Input X.• Input X changes its state; the Incident ID tags to activity messages forthis Input.• The driver is restarted while Input X is activating. A new Incident ID isissued and tagged to new activity messages for Input X.Incident Group Example:Guard Station Activities with Incident ID with Two Phase Acknowledge and Clear• Preconditions:• Incident Group A contains Input 1 and Event B.• Input 1 is configured to activate Event B when Input 1 is active.• Action:• Input 1 is activated to trigger Event B to activate.• Input 1 is deactivated.• Event B is acknowledged.• Event B is cleared.• Input 1 is activated to cause new Incident ID.C•CURE 800/8000 Software Configuration Guide 25–11