C•CURE 800/8000 Software Configuration Guide - Tyco Security ...

Protection InputsTo configure the protection input:1. In the Administration application choose Configure>Intrusion Zone.2. Select iSTAR Intrusion Zone. (There is no support for protection inputsin apC Intrusion Zones.)The Intrusion Zone Selection browser opens.3. Click Edit to edit an existing intrusion zone, or click New to configure anew one.4. Configure the intrusion zone as needed.5. On the Inputs tab, select the appropriate Available input(s) and add themto the Selected inputs list.6. In the Selected inputs list, select the one you want to designate as theProtection Input.7. Scroll to the right in the Selected inputs window, click in the ProtectionInput field, and select Yes (No is the default).8. Click OK to save the configured input, and click Close on the IntrusionZone Selection browser.Configuring Events for Protection InputsOn iSTAR controllers, you can configure an Event to activate if any of theintrusion zone’s inputs become active, even if the intrusion zone is disarmed.On the Events tab, select an event to activate for either or both modes:• “Event to Activate when not ready to arm”• “Event to activate when zone violated”The Not Ready to Arm event will be activated any time the intrusion zone hasoffnormal inputs (inputs that are activated when an intrusion zone isdisarmed) or open doors, regardless of whether the intrusion zone is armed ordisarmed. Figure 12-4 on page 12-27 shows the Events tab and modes thatmay be configured.12–26 C•CURE 800/8000 Software Configuration Guide