C•CURE 800/8000 Software Configuration Guide - Tyco Security ...

Configuring AreasMinimum OccupancyMinimum Occupancy, or N-man Rule, specifies that a minimum number ofpersonnel must enter the area at the same time to gain access. A minimumnumber must also remain in the specified area. You can also configure anevent to trigger when an area reaches its minimum occupancy. You can alsoconfigure minimum occupancy to count the number of personnel enteringand leaving an area without restricting access.Tasks for Configuring Area OccupancyYou can perform the following tasks from the Configure Area Occupancy tab:“Configuring Occupancy Settings for Areas” on page 2-10“Configuring Area Passthrough” on page 2-11“Setting Supervision Options” on page 2-11“Setting Supervision Options” on page 2-11“Setting Personnel Group Restrictions” on page 2-12Configuring Occupancy Settings for AreasTo Configure Occupancy Settings for Areas1. From the C•CURE 800/8000 Administration application menu, selectConfigure>Area. The Area Selection Browser opens.2. Select the Area you wish to edit and click Edit. The Configure Areadialog box opens.3. Click the Occupancy tab.4. Set the Maximum Occupancy for the Area by typing a number in thefield.5. If you want to count personnel in the area, rather than impose accessrestrictions based on that count, select Counting only, no Maximumaccess restrictions.2–10 C•CURE 800/8000 Software Configuration Guide