C•CURE 800/8000 Software Configuration Guide - Tyco Security ...

Configuring Intrusion Zone DoorsConfiguring Intrusion Zone DoorsTo add doors to an intrusion zone, select:• Configure>Intrusion Zone>apC Intrusion Zone>Edit/New>Doors (forapC configurations)• Configure>Intrusion Zone>iSTAR Intrusion Zone>Edit/New>Doors(for iSTAR configurations)Use the Add and Remove buttons to add and remove doors.apC Door OptionsTo set the door state to lock or unlock at access, highlight a selected door andclick Toggle Unlock.iSTAR Door OptionsTable 12-8 on page 12-19 shows iSTAR door configuration options. Use thehorizontal scroll bar in the Doors Selected area to display these options.Table 12-8: iSTAR Door Configuration OptionsOptionArm/DisarmStateDirectionCard ControlDescriptionLocked - access is granted with valid cardUnlocked - door is open. Access not required.Secure - door is locked and card access is not allowed. Door must bechanged to locked or unlocked to provide access.Used by the system to determine if a strike (unlock) action is required:In - For almost all intrusion zones, the In reader leads into the zone and theOut reader leads out of the zone.Out - Configured for atypical intrusion zones. Reverses the reader settings,so that the In reader leads out of the zone and the Out reader leads in.Refer to Table 12-11 for detailed information about this type ofconfiguration.Enables or disables readers in the zone to use card control to arm anddisarm the zone.C•CURE 800/8000 Software Configuration Guide 12–19