C•CURE 800/8000 Software Configuration Guide - Tyco Security ...

Configuring Intrusion Zone InputsConfiguring Intrusion Zone InputsTo add inputs to an intrusion zone, select:• Configure>Intrusion Zone>• apC Intrusion Zone>Edit/New (for apC configurations)• iSTAR Intrusion Zone>Edit/New (for iSTAR configurations)• On the Inputs tab, use the Add and Remove buttons to move inputs fromthe Available inputs list to the Selected inputs list.• Use the horizontal scroll bar at the bottom of the Selected inputs windowto display iSTAR input options.iSTAR Input OptionsThe iSTAR input options are shown in Table 12-9 on page 12-21.Table 12-9: iSTAR Input OptionsOptionEntrance DelayTriggerEntrance DelayShuntProtection InputDescriptionToggles the entrance delay trigger.• If yes, activation of this input while the intrusion zone is armedstarts the entrance delay.• If no, activation of this input while the intrusion zone is armed doesnot start the entrance delay.Toggles the entrance delay shunt.• If yes, the input is shunted (disregarded) during an entrancedelay.• If no, the input is not shunted, and activation of the input causesa zone violation.Toggles the activation of the input as a protection input.• If yes, the input is active as a protection input and is armed,monitoring the area within the Intrusion Zone.• If no, the input is not active as a protection input and is notmonitoring the area within the Intrusion Zone.If you select Yes for this option, you cannot also configure Yes for theEntrance Delay Trigger or the Entrance Delay Shunt.C•CURE 800/8000 Software Configuration Guide 12–21