C•CURE 800/8000 Software Configuration Guide - Tyco Security ...

Badge Layout DefinitionsTo Edit an Existing Badge Layout1. From the C•CURE 800/8000 Administration application menu, selectConfigure>Badge Layout. The Badge Layout Selection browser opens(see Figure 3-1 on page 3-2.2. Select a badge from the list and click Edit. The Badge Layout Editor opens(see Figure 3-2 on page 3-3).3. In the Badge layout file section, select the badge layout you want to editfrom the Badge layout file name drop-down list and click Edit File.4. The C•CURE ID Badge Designer opens, and you can edit the badgelayout.Badge Layout DefinitionsSee Table 3-1 on page 3-4 for descriptions of the fields and buttons on theBadge Layout dialog box.Table 3-1: Badge Layout Dialog Box DefinitionsField/ButtonNameDescriptionBadge Layout File NameCard Formats for MagneticStripe EncodingStripe 1/ Stripe 2 / Stripe 3Edit FileNew FileOKCancelDescriptionEnter a name for the badge layout.Enter a description of the badge layout.Enter a name for the badge layout file you want to configure.Spaces are not permitted in the filename.Enter up to 3 card formats for this badge layout for the 3standard tracks on a magnetic stripe card.These fields are not available until you define the magneticstripes in the Badge Designer.Click Edit File to edit an existing badge layout file.Click New File to create a new badge layout file.Click OK to accept your changes to the Badge Layout.Click Cancel to discard your changes to the Badge Layout.3–4 C•CURE 800/8000 Software Configuration Guide