C•CURE 800/8000 Software Configuration Guide - Tyco Security ...

Configuring Time Specifications7. Use the Day/Time drop-down list to select a day or days for the TimeSpecification. You can include Holiday Lists as special days (intervals) toprovide alternate schedules for the Holidays in the list.Example:Sat-SunHoliday List Boston8. Type in the hour and minute the Time Specification becomes active in theFrom fields, and type in the hour and minute that activation ends in theTo fields.9. Click Add to add the Day/Time to the Time Specification. The Day/Timeappears in the list of Currently Selected Day/Times for the TimeSpecification.NOTEIf you are configuring a Time Specification with an interval that uses aHoliday List in a system using the Distributed Holidays mode, you shouldusually select that same Holiday List to assign to the time specification forhost use. If this condition has not been met, a warning displays when youclick OK.Since, however, there may be cases where you want a Time Specificationto be used only by a set of iSTARs or apCs, the system will allow you tocontinue.10. Repeat Steps 7 through 9 to add more Day/Times to the TimeSpecification as needed.11. If you want an event/event group to occur when the Time Specification isactivated, double-click in the Activate event on TS activation field. A listof events appears. Choose the event/event group you want to add andclick Select.12. If you want an event/event group to arm when the Time Specification isactivated, double-click in the Arm event on TS activation field. A list ofevents appears. Choose the event/event group you want to add and clickSelect.13. Click OK to save your settings for the Time Specification.23–8 C•CURE 800/8000 Software Configuration Guide