C•CURE 800/8000 Software Configuration Guide - Tyco Security ...

Configuring Areas6. Set the Minimum Occupancy for the Area by typing a number in thefield. (This setting allows you to trigger an event when too few people arein an area, and/or prevent personnel from leaving an Area if the count isbelow the minimum.)7. If you want to count personnel in the area, rather than impose accessrestrictions based on a minimum, select Counting only, no Minimumaccess restrictions.8. Click OK when you have completed configuring Occupancy Settings forthis Area.Configuring Area PassthroughTo Configure Area Passthrough1. You can set a time for pass-through violation (a person entering the areacan only stay a limited time without triggering a violation) by typing thetime limit in hours and minutes in the Trigger pass-through violationafter field.2. Click OK when you have completed configuring Area Passthrough forthis Area.Setting Supervision OptionsTo Set Supervision Options1. If you want to exempt escorted visitor from needing an escort to enter thisArea, select Escorted Visitor type personnel do not need escort to enterthis area.2. If you want to specify that an Escort who is escorting visitors cannot leavethe area while escorted personnel remain in the area, select Escort mustbe present with escorted visitors.3. If you are using Supervisor and Supervised personnel roles, and youwant to make sure that Supervised personnel can’t enter or exit the areawithout Supervisor accompaniment, select Supervisor must be presentwith supervisees.C•CURE 800/8000 Software Configuration Guide 2–11