Junos OS Interfaces Command Reference - Juniper Networks

CHAPTER 4
Ethernet Interface Operational Mode
Commands
Table 24 on page 135 summarizes the command-line interface (CLI) commands that you
can use to monitor and troubleshoot aggregated Ethernet, Fast Ethernet, Gigabit Ethernet,
and 10-Gigabit Ethernet interfaces. Commands are listed in alphabetical order.
Table 24: Ethernet Interface Operational Mode Commands
Task
Copyright © 2012, Juniper Networks, Inc.
Clear dynamic VLAN interfaces.
Clear Link Aggregation Control Protocol (LACP) statistics.
Clear learned MAC addresses from the hardware and MAC
database. Static MAC addresses are not cleared.
Clear statistics that are collected for every MAC address,
including policer statistics, on a given physical or logical
interface.
Clear statistics that are collected for interface sets.
Clear the existing continuity measurement and restart
counting the operational uptime.
Clear ITU-T Y.1731 Ethernet frame delay measurement
(ETH-DM) delay statistics and ETH-DM frame counts. (MX
Series routers)
Clear Operation, Administration, and Management (OAM)
and connectivity fault management (CFM) linktrace
database information.
Clear all loss statistics maintained by CFM for a given
maintenance domain and maintenance association.
Command
clear auto-configuration interfaces
clear lacp statistics
clear interfaces mac-database
clear interfaces mac-database
statistics
clear interfaces interface-set statistics
clear oam ethernet
connectivity-fault-management
continuity-measurement
clear oam ethernet
connectivity-fault-management
delay-statistics
clear oam ethernet
connectivity-fault-management
linktrace path-database
clear oam ethernet
connectivity-fault-management
loss-statistics
135