Junos OS Interfaces Command Reference - Juniper Networks

Table 79: show ppp interface Output Fields (continued)
Field Name
IPCP
Field Description
Internet Protocol Control Protocol (IPCP) information.
• State—(All platforms except M120 and M320 routers) One of the following values:
• Ack-rcvd—A Configure-Request has been sent and a Configure-Ack has been received.
• Ack-sent—A Configure-Request and a Configure-Ack have both been sent, but a
Configure-Ack has not yet been received.
• Closed—Link is not available for traffic.
• Opened—Link is administratively available for traffic.
• Req-sent—An attempt has been made to configure the connection.
• State—(M120 and M320 routers) One of the following values:
• Ack-rcvd—A Configure-Request has been sent and a Configure-Ack has been received.
• Ack-sent—A Configure-Request and a Configure-Ack have both been sent, but a
Configure-Ack has not yet been received.
• Closed—Link is available (up), but no Open has occurred.
• Closing—A Terminate-Request has been sent but a Terminate-Ack has not yet been
received.
• Opened—Link is administratively available for traffic. A Configure-Ack has been both
sent and received.
• Req-sent—An attempt has been made to configure the connection. A Configure-Request
has been sent but a Configure-Ack has not yet been received.
• Starting—An administrative Open has been initiated, but the lower layer is still unavailable
(Down).
• Stopped—The system is waiting for a Down event after the This-Layer-Finished action,
or after sending a Terminate-Ack.
• Stopping—A Terminate-Request has been sent but a Terminate-Ack has not yet been
received.
• Last started—IPCP state start time.
• Last completed—IPCP state authentication completion time.
• Negotiated options:
Copyright © 2012, Juniper Networks, Inc.
Chapter 8: PPP Interface Operational Mode Commands
• compression protocol—Negotiate the use of a specific compression protocol. By default,
compression is not enabled.
• local address—Desired local address of the sender of a Configure-Request. If all four
octets are set to zero, the peer provides the IP address.
• primary DNS server—Negotiate with the remote peer to select the address of the primary
DNS server to be used on the local end of the link.
• primary WINS server—Negotiate with the remote peer to select the address of the primary
WINS server to be used on the local end of the link.
• remote address—IP address of the remote end of the link in dotted quad notation.
• secondary DNS server—Negotiate with the remote peer to select the address of the
secondary DNS server to be used on the local end of the link.
• secondary WINS server—Negotiate with the remote peer to select the address of the
secondary WINS server to be used on the local end of the link.
Level of
Output
extensive
453