Junos OS Interfaces Command Reference - Juniper Networks

Junos OS 12.1 Interfaces Command Reference
Table 74: T3 or E3 show interfaces Output Fields (continued)
Field Name
DS3 media or E3
media
HDLC configuration
420
Field Description
Counts of DS3 (T3) or E3 media-specific errors.
• Seconds—Number of seconds the defect has been active.
• Count—Number of times that the defect has gone from inactive to active.
• State—State of the error. State other than OK indicates a problem.
The DS3 or E3 media-specific error types can be:
• PLL Lock—Phase-locked loop out of lock
• Reframing—Frame alignment recovery time
• AIS—Alarm indication signal
• LOF—Loss of frame
• LOS—Loss of signal
• IDLE—Idle code detected
• YELLOW—Errors at the remote site receiver
• BPV—Bipolar violation
• EXZ—Excessive zeros
• LCV—Line code violation
• PCV—(DS3 only) Pulse code violation
• CCV—(DS3 only) C-bit coding violation
• FEBE—(DS3 only) Far-end block error
• LES—Line error seconds
• PES—(DS3 only) P-bit errored seconds
• PSES—(DS3 only) P-bit errored seconds (section)
• CES—(DS3 only) C-bit errored seconds
• CSES—(DS3 only) C-bit severely errored seconds
• SEFS—Severely errored framing seconds
• UAS—Unavailable seconds
Information about the HDLC configuration.
• Policing bucket—Configured state of the receiving policer.
• Shaping bucket—Configured state of the transmitting shaper.
• Giant threshold—Giant threshold programmed into the hardware.
• Runt threshold—Runt threshold programmed into the hardware.
• Idle cycle flag—Idle cycle flags.
• Start end flag—Start and end flag.
Level of Output
extensive
extensive
Copyright © 2012, Juniper Networks, Inc.