Junos OS Interfaces Command Reference - Juniper Networks

show interfaces destination-class
Syntax show interfaces destination-class
(all | destination-class-name logical-interface-name)
Release Information Command introduced before Junos OS Release 7.4.
all option introduced in Junos OS Release 8.0.
Description Display information about interfaces grouped by destination class.
Options all—Display information about all configured destination classes.
destination-class-name—Name of a logical grouping of prefixes that count packets having
the destination address matching those prefixes. Whenever a destination class is
specified, you must also specify a particular logical interface, not all interfaces.
logical interface-name—Name of a logical interface.
Additional Information For interfaces that carry IPv4, IPv6, or Multiprotocol Label Switching (MPLS) traffic, you
Required Privilege
Level
can maintain packet counts based on the entry and exit points for traffic passing through
your network. Entry and exit points are identified by source and destination prefixes
grouped into sets defined as source classes and destination classes. For more information,
see the Junos OS Network Interfaces Configuration Guide.
view
List of Sample Output show interfaces destination-class all on page 34
Output Fields Table 13 on page 33 lists the output fields for the show interfaces destination-class
command. Output fields are listed in the approximate order in which they appear.
Table 13: show interfaces destination-class Output Fields
Field Name
Logical interface
Destination class
Packets
Bytes
Copyright © 2012, Juniper Networks, Inc.
Field Description
Name of the logical interface.
Chapter 2: Common Interface Commands
Name of destination class usage (DCU) counters per class for this
interface.
Packets going to designated user-selected prefixes.
Bytes going to designated user-selected prefixes.
33