Junos OS Interfaces Command Reference - Juniper Networks

Junos OS 12.1 Interfaces Command Reference
Table 151: IP-over-IP show interfaces Output Fields (continued)
Field
Encapsulation
Input packets
Output packets
Traffic statistics
Local statistics
Transit statistics
Protocol
protocol-family
MTU
Generation
Route table
Flags
Sample Output
888
show interfaces
(IP-over-IP)
Field Description
Encapsulation on the logical interface.
Number of packets received on the logical interface.
Number of packets transmitted on the logical interface.
Total number of bytes and packets received and transmitted on the logical
interface. These statistics are the sum of the local and transit statistics. When
a burst of traffic is received, the value in the output packet rate field might briefly
exceed the peak cell rate. It takes awhile (generally, less than 1 second) for this
counter to stabilize.
• Input rate—Rate of bits and packets received on the interface.
• Output rate—Rate of bits and packets transmitted on the interface.
Statistics for traffic received from and transmitted to the Routing Engine. When
a burst of traffic is received, the value in the output packet rate field might briefly
exceed the peak cell rate. It takes awhile (generally, less than 1 second) for this
counter to stabilize.
Statistics for traffic transiting the router. When a burst of traffic is received, the
value in the output packet rate field might briefly exceed the peak cell rate. It
takes awhile (generally, less than 1 second) for this counter to stabilize.
Protocol family configured on the logical interface, such as iso, inet6, or mpls.
Protocol family configured on the logical interface. If the protocol is inet, the IP
address of the interface is also displayed.
MTU size on the logical interface.
Unique number for use by Juniper Networks technical support only.
Routing table in which the logical interface address is located. For example, 0
refers to the routing table inet.0.
Information about the protocol family flags. Possible values are described in
the “Family Flags” section under “Common Output Fields Description” on
page 125.
Level of Output
All levels
None specified
None specified
detail extensive
detail extensive
detail extensive
detail extensive none
brief
detail extensive none
detail extensive
detail extensive
detail extensive none
user@host> show interfaces ip-0/0/0
Physical interface: ip-0/0/0, Enabled, Physical link is Up
Interface index: 133, SNMP ifIndex: 27
Type: IPIP, Link-level type: IP-over-IP, MTU: Unlimited, Speed: 800mbps
Device flags : Present Running
Interface flags: SNMP-Traps
Input rate : 0 bps (0 pps)
Output rate : 0 bps (0 pps)
Copyright © 2012, Juniper Networks, Inc.