Junos OS Interfaces Command Reference - Juniper Networks

show lacp interfaces
Syntax show lacp interfaces
Release Information Command introduced in Junos OS Release 7.6.
Description Display Link Aggregation Control Protocol (LACP) information about the specified
Required Privilege
aggregated Ethernet, Fast Ethernet, or Gigabit Ethernet interface.
Options none—Display LACP information for all interfaces.
Level
interface-name—(Optional) Display LACP information for the specified interface:
view
• Aggregated Ethernet—aenumber
• Fast Ethernet—fe-fpc/pic/port
• Gigabit Ethernet—ge-fpc/pic/port
NOTE: The show lacp interfaces command returns the following error message
if your system is not configured in either active or passive LACP mode:
“Warning: lacp subsystem not running – not needed by configuration”
List of Sample Output show lacp interfaces (Aggregated Ethernet) on page 290
show lacp interfaces (Gigabit Ethernet) on page 290
Output Fields Table 42 on page 287 lists the output fields for the show lacp interfaces command. Output
fields are listed in the approximate order in which they appear.
Table 42: show lacp interfaces Output Fields
Field Name
Aggregated interface
Field Description
Copyright © 2012, Juniper Networks, Inc.
Aggregated interface value.
Chapter 4: Ethernet Interface Operational Mode Commands
287