Junos OS Interfaces Command Reference - Juniper Networks

Junos OS 12.1 Interfaces Command Reference
Table 121: Channelized E1 and Channelized E1 IQ show interfaces Output Fields (continued)
Field Name
E1 media
HDLC configuration
Interface transmit
queues
686
Field Description
Active alarms and defects, plus counts of specific E1 errors with detailed
information.
• Seconds—Number of seconds the defect has been active.
• Count—Number of times that the defect has gone from inactive to active.
• State—State of the error. State other than OK indicates a problem.
The E1 media-specific error types can be:
• SEF—Severely errored framing
• BEE—Bit error
• AIS—Alarm indication signal
• LOF—Loss of frame
• LOS—Loss of signal
• YELLOW—Errors at the remote site receiver
• BPV—Bipolar violation
• EXZ—Excessive zeros
• LCV—Line code violation
• PCV—Pulse code violation
• CS—Carrier state
• FEBE—Far-end block error
• LES—Line error seconds
• ES—Errored seconds
• BES—Bit error seconds
• SES—Severely errored seconds
• SEFS—Severely errored framing seconds
• UAS—Unavailable seconds
Information about the HDLC configuration.
• Giant threshold—Giant threshold programmed into the hardware.
• Runt threshold—Runt threshold programmed into the hardware.
• Timeslots—Configured time slots for the interface.
• Line encodingHDB3—Line encoding used.
Names of the transmit queues and their associated statistics for each DS0
channel on the Channelized E1 to DS0 PIC.
• B/W—Queue bandwidth as a percentage of the total interface bandwidth.
• WRR—Weighted round robin (in percent).
• Packets—Number of packets transmitted.
• Bytes—Number of bytes transmitted.
• Drops—Number of packets dropped.
• Errors—Number of packet errors.
Level of Output
extensive
extensive
extensive
Copyright © 2012, Juniper Networks, Inc.